2011 Arctic Cat 450/550/650/700/1000 ATV Service Manual, Page 273Get this manual
INSTALLING 1Place the return spring into the throttle control; then place the bushing and actuator arm into positionSecure with the cap screw, lock washer, and washer INSTALLING 1Place the spring into position between the upper shift arm and shift lever; then making sure the O-rings are in place on the axle, secure the shift lever to the arm with the existing axle and nut2Place the shift rod into position on the shift lever and secure with the existing E-clip3Check shift lever adjustment (see Section 2); then tighten jam nut(s) securely4Install the left-side splash panel
Speedometer TachometerLCD
2Using pair of needle-nose pliers, place the spring into position on the actuator arm
REPLACING To replace the speedometer, use the following procedure1Remove the two reinstallable rivets securing the instrument pod; then remove the ignition switch retaining ring2Remove the two nuts securing the mounting studs; then remove the speedometer and disconnect the multi-pin connector3Mount the speedometer and secure with the two nuts; then connect the multi-pin connector