2011 Arctic Cat 450/550/650/700/1000 ATV Service Manual, Page 210Get this manual
3Using multimeter, connect the black tester lead to the black socket (GND) on the analyzer and the red tester lead to the white socket (VAR); then select the Voltage position PR544
NOTE: Prior to testing the TPS, inspect the three-wire plug connector on the main harness and the three-pin plug on the TPS for contamination, broken pins, andor corrosion
4Adjust the TPS until reading of 0.68 DC volts is obtained; then tighten the screw securelyOpen and close the throttle and determine the reading returns to 0.68 DC voltsReadjust as necessary
2Make sure the ignition switch is in the OFF position; then select the DC Voltage position on the meter3Connect the red tester lead to terminal and the black tester lead to terminal ATurn the ignition switch to the ON positionThe meter should read approximately 5.0 DC volts