2011 Arctic Cat 450/550/650/700/1000 ATV Service Manual, Page 208Get this manual
INSTALLINGADJUSTING
1Place the TPS into position on the throttle body and secure with the two screwsDo not tighten at this time2Connect the main harness to the TPS3Locate the diagnostic connector under the seat next to the PDM; then install the test plug from Test PlugError Code List kit onto the connector4Turn the ignition switch to the ON position and note the position of the TPS indicator icon (A, B, or C); then adjust the TPS until the TPS icon appears in the center position (B)
6Cycle the throttle lever from idle to approximately half throttle position several times; then return the throttle to idleThe display should return to (B) position7Remove the test plug; then install the left-side engine cover
Throttle Position Sensor (TPS) (450)