2011 Arctic Cat 450/550/650/700/1000 ATV Service Manual, Page 204Get this manual
ECU Error Codes (550700700 Cruiser700 Mud Pro1000) If sensor fails or an out-of-tolerance signal is sensed by the ECU, an error code will be generated by the ECUThis will result in the analog needle swinging full scale (if equipped) or the LCD gauge going blank (if equipped)The EFI icon will flash
609596979899 =
Cooling Fan Relay Sensor Power Incorrect ECU ECU Memory Power (constant battery power) ECU to Gauge Comm LinkH2 StartRun Not Possible (active code only)
After all active error codes are cleared, clear stored error code(s) using the following procedureNOTE: The ignition switch should be in the OFF position
Will initiate code 99
To read the error code(s), use the following procedure1Make sure the ignition switch is in the OFF position; then remove the seat2Locate the diagnostic plug next to the PDM; then remove the black rubber cap3Connect the Diagnostic Harness to the diagnostic plug
1With the diagnostic harness connected to the diagnostic plug and the drive select switch in the 4WD position, hold the reverse override switch down and turn the ignition switch to the ON position2After ten seconds, release the reverse override switch and turn the ignition switch to the OFF position; then turn the ignition switch to the ON positionThe display should read AC00 (no fault detected)NOTE: If the LCD still displays an error code, continue troubleshooting the appropriate component