2011 Arctic Cat 450/550/650/700/1000 ATV Service Manual, Page 87Get this manual
3Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder in figure eight motionInspect the sealing surface for any indication of high spotsA high spot can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move the cylinder in figure eight motion until uniform bright metallic finish is attained NOTE: To produce the proper 60 cross-hatch pattern, use low RPM drill (600 RPM) at the rate of 30 strokes per minuteIf honing oil is not available, use lightweight petroleum-based oilThoroughly clean cylinder after honing using soap and hot waterDry with compressed air; then immediately apply oil to the cylinder boreIf the bore is severely damaged or gouged, replace the cylinder
CAUTION
Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result
4If any measurement exceeds the limit, replace the cylinder and pistonCC129D
Measuring Camshaft Runout