2011 Arctic Cat 450/550/650/700/1000 ATV Service Manual, Page 61Get this manual
NOTE: The arrows on the V-belt should point in direction of engine rotation
NOTE: At this point, the cap screw can be removed from the driven pulley face
15Making sure the movable drive face rollers are in position, pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaft
17Rotate the V-belt and drivedriven assemblies until the V-belt is flush with the top of the driven pulley18Install two alignment pins and place new V-belt cover gasket into position on the clutch coverIn crisscross pattern, tighten cap screws to ft-lb