2011 Arctic Cat 400 TRV ATV Service Manual, Page 144Get this manual
INSTALLING 1Place the return spring into the throttle control; then place the bushing and actuator arm into positionSecure with the cap screw, lock washer, and washer INSTALLING 1Place the spring into position between the upper shift arm and shift lever; then making sure the O-rings are in place on the axle, secure the shift lever to the arm with the existing axle and nut2Place the shift rod into position on the shift lever and secure with the existing E-clip3Check shift lever adjustment (see Section 2); then tighten jam nut(s) securely4Install the left-side splash panel
LCD Gauge
REPLACING 1Remove the two reinstallable rivets securing the instrument pod; then remove the ignition switch retaining ring2Remove the two nuts securing the mounting studs; then remove the gauge and disconnect the multi-pin connector3Mount the gauge and secure with the two nuts; then connect the multi-pin connector4Install the instrument pod and secure with the reinstallable rivets5Secure the ignition switch with the retaining ring