2011 Arctic Cat 400 TRV ATV Service Manual, Page 133Get this manual
1Clean all rack components using pressure washer2Inspect all welds for cracking or bending3Inspect threaded areas of all mounting bosses for stripping4Inspect for missing decals andor reflectorsINSTALLING 1Place the rack into position on the frame and front fender panelInstall the cap screws and lock nuts and finger-tighten onlyAF789D
9Measure the distance between the marks (at height parallel to the belly panel) at the front side; then record the measurement10Push the ATV forward until the marks are parallel to the belly panel on the back side; then measure the distance between the marks11The difference in the measurements must show 18-14 intoe-out (the front measurement 18-14 inmore than the rear measurement)12If the difference in the measurements is not within specifications, adjust both tie rods equally until within specificationsNOTE: Prior to locking the jam nuts, make sure the ball joints are at the center of their normal range of motion and at the correct angle
2Install the two cap screws and lock nuts securing the rack to the fendersTighten all hardware securely