2011 Arctic Cat 400 TRV ATV Service Manual, Page 120Get this manual
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
3Route the brake hose through the upper A-arm shock absorber mount; then secure the hose to the A-arm with cable tie and grommet
1Clean all A-arm components using pressure washer2Clean the ball joint mounting hole of all residual Loctite, grease, oil, or dirt for installing purposes3Inspect the A-arm for bends, cracks, and worn bushings4Inspect the ball joint mounting holes for cracks or damage5Inspect the frame mounts for signs of damage, wear, or weldment damageINSTALLING 1Apply Loctite Primer "T" to the arm socket; then apply green Loctite #609 to the entire outside diameter of the ball jointInstall the ball joint into the A-arm and secure with the snap ringDE054A