2011 Arctic Cat 400 TRV ATV Service Manual, Page 110Get this manual
7Install the wheelTighten to 40 ft-lb8Remove the ATV from the support stand and release the brake lever lockINSTALLING FRONT DRIVE AXLE 1Position the drive axle in the gear case and steering knuckle; then insert the upper A-arm ball joint into the steering knuckleSecure with cap screw tightened to 50 ft-lb2Place the brake hose into position on the upper A-arm; then secure the lower shock eyelet to the A-arm with cap screw and new lock nutTighten to 50 ft-lb3Secure the tie rod to the steering knuckle with new lock nutTighten securely; then install and spread new cotter pin4Slide the hub wbrake disc into position in the steering knuckle followed by washer and hex nutTighten finger-tight at this time5Install the brake caliper on the steering knuckle using new "patch-lock" cap screwsTighten to 20 ft-lb; then pump up the hand brake lever and engage the brake lever lockPR729B