2011 Arctic Cat 400 TRV ATV Service Manual, Page 107Get this manual
NOTE: If new housing is being installed, tighten the cap screws to 28 ft-lb CF278
CAUTION
Make sure the tool is free of nicks or sharp edges or damage to the seal may occur
3Repeat steps 1-2 for the opposite sideINSTALLING DIFFERENTIAL 1Align the splined input yoke with the front output splines; then place the differential into position on the frame and install the cap screws, washers, and flex-lock nutsTighten to 38 ft-lbMake sure the rubber boot is properly seated on the input yoke
RemovingInstalling Axle Seal