2011 Arctic Cat 400 TRV ATV Service Manual, Page 14Get this manual
2Connect the new bulb assembly to the wiring harness connector; then insert into the headlight housing and rotate fully clockwiseTo replace the taillight-brakelight bulb, use the following procedure1Turn the bulb socket assembly counterclockwise and remove from the housing 737-651B
4After all the lubricant has been drained, install the drain plugs and tighten to 45 inlb5Pour the appropriate amount of approved SAE 80W-90 hypoid gear lubricant into the filler hole6Install the fill plugs and tighten to 16 ft-lbNOTE: If the differentialrear drive lubricant is contaminated with water, inspect the drain plug, fill plug, andor bladderCF135A
2Pull the bulb straight out of the socket; then insert new bulb
CAUTION
Water entering the outer end of the axle will not be able to enter the rear drive unless the seals are damaged
NutsBoltsCap Screws