2011 Arctic Cat 400 TRV ATV Service Manual, Page 13Get this manual

2011 Arctic Cat 400 TRV ATV Service Manual, Page 13

STRAINER 1Remove the belly panel2Remove the cap screws securing the oil strainer cap; then remove the cap 6Install the belly panel
Front DifferentialRear Drive Lubricant
When changing the lubricant, use approved SAE 80W-90 hypoid gear lubeTo check lubricant, remove the fill plug; the lubricant level should be inbelow the threads of the plugIf low, add SAE approved 80W-90 hypoid gear lubricant as necessaryTo change the lubricant, use the following procedure1Place the ATV on level ground2Remove each fill plug

3Remove the two cap screws securing the strainer; then remove the strainerNOTE: Thoroughly clean any sealant from the oil strainer cap

Back to 2011 Arctic Cat 400 TRV ATV Service Manual