2011 Arctic Cat 366SE ATV Service Manual, Page 111Get this manual
3Inspect each tire for cuts, wear, missing lugs, and leaks 2Inspect the tires for damage, wear, or punctures
INSTALLING
Install each wheel on its hubTighten to 40 ft-lbNOTE: Make sure each wheel is installed on its proper hub as noted in removing (the "rotation arrow" (if applicable) must indicate forward direction of rotation)
! WARNING
Do not operate the ATV if tire damage existsNOTE: If repair is needed, follow the instructions found on the tire repair kit or remove the wheel and have it repaired professionallyNOTE: Be sure all tires are the specified size and have identical tread pattern
3Check the front wheel toe-in and toe-out and adjust as necessary (see SteeringFrame)4Test drive the ATV on dry, level surface and note any pulling to the left or right during acceleration, deceleration, and brakingNOTE: If pulling is noted, measure the circumference of the front and rear tires on the pulling sideCompare the measurements with the tires on the opposite sideIf pulling is noted during braking only, check and adjust the brakes as necessary and recheck operation (see Periodic Maintenance)