2011 Arctic Cat 366SE ATV Service Manual, Page 84Get this manual
2Connect the black tester lead to the black wire; then connect the red tester lead to the greenyellow wire3The meter must show battery voltageNOTE: If the meter does not show voltage, inspect bulb, fuses, wiring harness, connectors, and switches Voltage
1Release the wire connectors from the frame; then disconnect the connectorsNOTE: Perform this test on the main harness side of the connectors
BACK-UP LIGHTS
The connectors are located on the rear frame supports attached by metal tabThey may be released from the frame by depressing the release with small screwdriver
2Connect the black tester lead to the brownlavender wire; then connect the red tester lead to the lavenderred wire3Set the tester to DC VOLTS; then turn the ignition switch to the ON position and move the shift lever to the (reverse) positionThe meter must show battery voltageNOTE: If the meter does not show battery voltage, use the following procedure to troubleshoot
4Remove the black tester lead from the brownlavender wire and connect to suitable groundAIf the meter shows battery voltage, troubleshoot the gear shift position switch connector or the gear shift position switchBIf the meter does not show battery voltage, inspect the LIGHTS fuse, ignition switch, or the main wiring harness