2011 Arctic Cat 366SE ATV Service Manual, Page 78Get this manual
RELAYS The relays are identical plug-in type located on the power distribution moduleRelay function can be checked by switching relay positionsThe relays are interchangeableNOTE: The module and wiring harness are not serviceable component and must be replaced as an assembly
PEAK VOLTAGE
NOTE: All of the peak voltage tests should be made using the Fluke Model 73 Multimeter or Fluke Model 77 Multimeter with Peak Voltage Reading AdapterIf any other type of tester is used, readings may vary due to internal circuitryNOTE: The battery must be at full charge for these tests
Ignition Coil
The ignition coil is on the frame above the engineTo access the coil, the left side panel must be removed
PrimaryCDI
NOTE: The CDI is located on the electrical tray in front of the steering shaft
RESISTANCE CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
NOTE: For these tests, the meter selector should be set to the OHMS position and the primary wire(s) should be disconnected