2011 Arctic Cat 366SE ATV Service Manual, Page 51Get this manual
14Slide the fixed drive face assembly onto the front shaft15Spread the faces of the driven pulley by threading V-belt cover cap screw into the fixed driven face and tightening until the faces open sufficiently to allow the V-belt to drop into the pulley approximately 34 in MD1117
12Install the air intake plateApply red Loctite #271 to the threads of the three Phillips-head cap screws; then install and tighten securely
NOTE: The arrows on the V-belt should point in direction of engine rotation
16Making sure the movable drive face rollers are in position, pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaftMD1342