2011 Arctic Cat 350/425 ATV Service Manual, Page 17Get this manual
TIRE INFLATION PRESSURE Front and rear tire inflation pressure should be 27.6 kPa (4.0 psi) HEADLIGHTS
NOTE: The bulb portion of headlight is fragileHANDLE WITH CAREWhen replacing headlight bulb, do not touch the glass portion of the bulbIf the glass is touched, it must be cleaned with dry cloth before installingSkin oil residue on the bulb will shorten the life of the bulb
DriveshaftCoupling
The following drive system components should be inspected periodically to ensure proper operationASpline lateral movement (slop)BCoupling cracked, damaged, or worn
! WARNING
Do not attempt to remove bulb when it is hotSevere burns may result
To replace the headlight bulb, use the following procedure1Remove the protective rubber boot from the rear of the headlight housing; then remove the wiring harness connector from the back of the headlight bulb
NutsBoltsCap Screws
Tighten all nuts, bolts, and cap screwsMake sure rivets holding components together are tightReplace all loose rivetsCare must be taken that all calibrated nuts, bolts, and cap screws are tightened to specifications