2011 Arctic Cat 150 ATV Service Manual, Page 32Get this manual

2011 Arctic Cat 150 ATV Service Manual, Page 32

3Install the pins and spacers into the fixed face hub; then pack the cam slots in the movable face with multi-purpose grease KM373

7Using suitable holding fixture, tighten the drive plate nut to 43 ft-lbKM384

4Install the spring seat over the hub and movable face hub
Installing Left-Side Components
ADrive Pulley BDriven PulleyCentrifugal Clutch Assembly CV-Belt Cover AT THIS POINT
If the gear shift position switch was removed, install it into the crankcase using new O-ringTighten the cap screw securely

Back to 2011 Arctic Cat 150 ATV Service Manual