2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 225Get this manual
4Turn the ignition switch to the OFF positionTighten the jam nut securely; then install the protector sleeve on the adjuster assembly Shift Lever
REMOVING 1Remove the seats and center consolePR342C
INSTALLING Align the mounting holes with the holes in the splash panel and secure with the two torx-head screws and nuts; then snap the throttle cable holding grommet into the actuator arm
2Remove the flange nut and shoulder screw from the shift lever pivot; then remove the shift leverAccount for the shifter spring
Front Differential Lock
ADJUSTING CABLE 1With the toggle in the pushed-in position, slide the rubber protector sleeve (A) off the cable near the toggle; then loosen the jam nut (B) and turn the cable adjuster (C) to achieve 3-4 mm (0.12-0.16 in free-travel measured at the togglePR340
INSTALLING 1With the shifter spring in place on the shift lever, install the shift lever onto the shift axle2Install the shoulder screw and secure with the flange nut (threads coated with blue Loctite #243)Tighten to 20 ft-lb