2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 220Get this manual
INSPECTING MUFFLER NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
3Lower the cargo box; then remove the four cap screws (from step 2)4With the help of an assistant or an adequate lift, remove the cargo box from the vehicleAccount for four pivot housingsCLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Inspect muffler externally for cracks, holes, and dents2Inspect the muffler internally by shaking the muffler back and forth and listening for rattles or loose debris inside the mufflerNOTE: For additional details on cleaning the mufflerspark arrester, see Section 2
1Clean all cargo box components with soap and water2Inspect the cargo box for cracks, tears, and loose hardware3Inspect the welds of the cargo box frame for cracking or bending4Inspect the cargo box gate latches for smooth operationINSTALLING 1With the help of an assistant or an adequate lift, set the cargo box into position on the frame; then position the two upper pivot housings between the cargo box and frameLightly grease the pivot housings2Align the holes in the upper pivot housings with the holes in the cargo box; then install the lower pivot housings and secure with the four shoulder cap screwsTighten to 20 ft-lb3Raise the cargo box; then connect the lift support to the frame, install the cap screw and nut, and tighten the nut securely4Lower the cargo box and lock into position