2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 217Get this manual
To adjust the wheel alignment, use the following procedure1Center the steering wheel; then using an open-end wrench to hold the tie rod ends, loosen the right-side and left-side jam nuts
Front Bumper Assembly
REMOVING Remove four cap screws and nutsAccount for four lock washers and eight flat washers
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all bumper components with hot, soapy water2Inspect all welds for cracking or bendingPR085A
INSTALLING Place the bumper assembly into position on the frame; then secure with the four cap screws and nuts making sure the flat washers and lock washers are properly positionedTighten securely