2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 211Get this manual
NOTE: Always attach the crow-foot to the torque wrench with the open end 90 to the torque wrench handle to ensure accurate torque application PR309
3Apply green Loctite #270 to the cap screw; then secure the lower steering shaft joint to the pinion shaft making sure the shaft does not protrude into the joint beyond the clamping surface
5Install the rack boot and secure with the clamps; then loosely install the jam nut and outer tie rod end
! WARNING
INSTALLING 1Place the rack and pinion assembly into position from the right-side of the vehicle; then secure with the two cap screws, washers, and nutsTighten to 50 ft-lb
Allowing the lower steering shaft joint to extend too far onto the pinion shaft could cause binding or lock-up of the steering joint resulting in loss of steering control
4Tighten the cap screw to 36 ft-lb; then check that the steering wheel turns freely5Install the tie rod ends into the steering knuckles; then secure with the castle nuts (coated with red Loctite #271) tightened to 30 ft-lb6Install the cotter pins and spread to secure7Install the wheels and tighten to 45 ft-lbCheck the steering system for full and free travel; then check and adjust the front wheel alignment (see CheckingAdjusting Front Wheel Alignment in this section)