2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 210Get this manual
INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
3Clean all Loctite from the threads in the rack and if the tie rod is to be reused, clean the tie rod threads also
1Inspect the tie rod ends for damaged threads, torn boots, or excessive wear2Inspect the tie rods for bends or deformation3Inspect the rack and pinion-to-tie rod boots for tears or deterioration
4Coat the thread with red Loctite #271; then install the tire rod into the rack and using an appropriate crow-foot, tighten to 52 ft-lb
4Check boot clamps for security5Check that the rack and pinion assembly operates smoothly with no binding from full-left to full-right position6Inspect for grease seepage from the rack and pinion assemblyNOTE: The steering assembly (rack and pinion) is not repairable and must be replaced as an assembly; however, the tie rods and boots are replaceablePR527