2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 207Get this manual
TIRE INFLATION PRESSURE Front and rear tire inflation pressure should be 0.70 kgcm (10 psi)REMOVING 1Secure the vehicle on support stand to elevate the wheels 2Tighten to 45 ft-lbCHECKINGINFLATING 1Using an air pressure gauge, measure the air pressure in each tireAdjust the air pressure as necessary to meet the recommended inflation pressure
! WARNING
Make sure the vehicle is solidly supported on the support stand to avoid injury
2Remove the nuts securing the wheels; then remove the wheelsCLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean the wheels and hubs with parts-cleaning solvent2Clean the tires with soap and water3Inspect each wheel for cracks, dents, or bends4Inspect each tire for cuts, wear, missing lugs, and leaksINSTALLING 1Install each wheel on its hub and secure with the existing hardware
2Inspect the tires for damage, wear, or punctures
! WARNING
Do not operate the vehicle if tire damage exists