2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 205Get this manual
NOTE: During assembly, new cotter pins should be installed PR260
13Install the wheel and tighten to 45 ft-lbAF618D
14Remove the vehicle from the support stand
8Apply grease to the hub and drive axle splines; then install the hub assembly onto the drive axle
Rear A-Arms
REMOVING 1Secure the vehicle on support stand to elevate the wheels
! WARNING
Make sure the vehicle is solidly supported on the support stand to avoid injuryPR290A
2Set the parking brake3Remove the wheel4Remove the cotter pin securing the hex nut; then remove the hex nut5Remove the cap screws and lock nut securing the shock absorber to the frame and lower A-arm; then remove the shock absorber6Remove the cap screws securing the boot guard to the lower A-arm