2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 194Get this manual
CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all hub components2Inspect all threads for stripping or damage3Inspect the brake disc (if applicable) for cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearREPLACING WHEEL STUDS 1Secure the hub in suitable holding fixture and remove the brake disc (if applicable)2Drive the damaged stud out of the hub; then place the new stud into the hub and thread on an appropriate flange nutPR254B
3Install the hub assembly onto the axle; then set the parking brake
4Secure the hub assembly with the nutTighten to 200 ft-lb; then secure with new cotter pinNOTE: If the cotter pin can not be inserted due to misalignment of the hole in the axle and the slots in the nut, tighten the nut until properly aligned