2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 191Get this manual
1Drain the lubricant from the rear gear casedifferential; then remove both rear drive axles (see Drive Axles in this section)2Remove the driveline brake caliper; then cut the rear-most propeller shaft boot clamp and slide the boot forward3Remove the boot clamps on the rear driveline boot4Remove the two cap screws and lock nuts securing the rear gear casedifferential to the frame; then remove the gear casedifferential through the upper left-side of the frame and lift out the top GZ392
AT THIS POINT
For servicing the input shaft, pinion gear, needle bearing, and axle seal, see Front Differential in this section