2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 189Get this manual
ASSEMBLING AXLES 1Install the inner boot with the small clamp making sure the ends of the clamp are positioned correctlyNOTE: The boot is positioned correctly when the small end of the boot seats down into the recessed groove
CAUTION
The bearing ring must go onto the shaft with the side without splines facing toward the small clamp of the inner boot or severe damage will result
5Secure the bearing ring with the snap ring making sure the sharp side of the snap ring faces away from the boot
2Using the boot clamp tool, secure the small clamp of the inner boot
6Making sure the marks made during disassembling align, slide the housing over the bearing ring; then completely seat the bearing ring into the housing and install the snap ringNOTE: Pull the bearing ring out of the housing until it contacts the snap ring; then slide the ring in half wayThis will purge air from the housing and ensure the bearing is packed properly