2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 186Get this manual

2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 186


12Install the wheels and tighten to 45 ft-lb13Remove the vehicle from the support stand14Install the belly panel
5Remove the cap screw and lock nut securing the knuckle to the upper A-armDiscard the lock nut
Drive Axles
REMOVING REAR DRIVE AXLE 1Secure the vehicle on support stand to elevate the wheels
! WARNING
Make sure the vehicle is solidly supported on the support stand to avoid injury

2Set the parking brake; then remove the wheels3Remove the cotter pins securing the axle nuts; then remove the nuts

Back to 2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual