2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 174Get this manual
INSTALLING 1Lubricate the O-rings on the actuator; then ensure that all mounting surfaces are clean and free of debris2Align the actuator with the selector shaft and slide it forward onto the shaft taking care to engage the cap screw in the slot of the front mounting tabNOTE: Make sure to properly align the differential lock actuator lever with the hole in the differential lock plunger NOTE: It is important to tighten this cap screw while the others are loose to ensure proper seating of the actuator
5Tighten the remaining cap screws; then connect the electrical plug to the main harness6Turn the ignition switch to the ON position and check the operation by shifting the selector switch several times7Secure the wiring harness to the frame with nylon cable tie; then install the inner fender panel
Front Differential
REMOVING 1Remove the belly panel; then place the vehicle on jack stands adjusted high enough to allow working from the underside of the vehicleNOTE: The jack stands should be placed under the main frame to avoid contact with front suspension components