2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 141Get this manual
4Remove the cap screws securing the throttle body to the manifold; then lift the throttle body off the manifoldAccount for an O-ring
3Connect the TPS connector (A), MAP sensor connector (B), and ISC connector (C) to the throttle body; then install the air inlet boot and tighten the clamps securely
5Remove the screw securing the throttle actuator cover to the throttle body; then remove the cover6Remove the throttle cable from the actuator arm7Loosen the outer jam nut securing the throttle cable to the throttle bodyThe throttle body can now be removed from the vehicle8Use tape to cover and seal the intake opening
4Install the center console and seats making sure the seats lock securely in place
Gas Tank
! WARNING
Whenever any maintenance or inspection is made on the fuel system during which there may be fuel leakage, there should be no welding, smoking, open flames, etc in the area