2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 136Get this manual
18Connect the throttle cable to the throttle arm; then install the cable housing into the throttle body housing and tighten the nuts securely19Adjust throttle cable free-play (see Section 2); then install the throttle cable cover
22Route the engine harness through the shifter support brackets as marked during disassembly and secure with nylon cable ties
20Install the shift cable support bracket and secure with two cap screws; then tighten to ft-lb and install the E-clip securing the shift cable to the shift arm
23Connect the front spark plug cap and front ignition coil; then install the front and rear injector connectors (A), MAP sensor (B), parking brake warning switch (C), reverse override switch connector (D), and ISC valve (E)