2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 133Get this manual
5Lubricate the splines on the front driveshaft with multi-purpose grease; then align the match marks and install the driveshaft into the front output joint
7Install new grafoil gasket in the rear cylinder head; then place the rear exhaust pipe into position and loosely secure with two cap screws
PR641A PR639
6Align the match mark on the front drive flange to mark on the front universal joint flange and secure with three cap screwsTighten to 40 ft-lb and slide the rubber boot back into position