2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 131Get this manual
5Tighten the mm cap screws to ft-lb and the mm cap screws to 20 ft-lb using the pattern shown and turning the shafts frequently to ensure there is no bindingNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
7Make sure the locating pins on the front and rear bearings are correctly seated in the crankcase8Install two locating pins into the upper crankcase assembly; then apply thin bead of silicone sealant to the lower crankcase cover
GZ452A GZ457A
NOTE: Cap screw number eight (8) is installed from the right sideNOTE: If the secondary drivedriven assemblies have been disassembled, refer to Servicing Center Crankcase Components for proper gear tooth contact and backlash