2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 117Get this manual
SECONDARY OUTPUT DRIVE GEARS Initial Set-Up NOTE: If the secondary output driven shaft is replaced or disassembled, the initial set-up must be performed to establish correct gear tooth contactIf only the secondary output driveshaft or secondary output driven gear are replaced, proceed to Correcting Backlash in this sub-section
1Install new bearing (A) onto the secondary driven shaft (B) making sure the bearing locating groove is directed away from the driven gear splines
MT008A MT011A
2Using suitable press, install the driven gear (C) on the shaft until the gear firmly seats on the shoulder of the shaft
4Install new seal (F), output yoke (G), and nut (H) coated with red Loctite #271 and tighten to 59 ft-lb