2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 105Get this manual
13Install the starter motor with new O-ring lightly lubricated with grease; then tighten the mounting cap screws to ft-lb Removing Right-Side Components
ACVT Cover BDriven Pulley CClutch Cover DCentrifugal Clutch 1Remove the cap screws securing the CVT cover; then using rubber mallet, gently tap on the cover tabs to loosen the coverAccount for gasket and two alignment pins
14Using Seal Protector Tool, install the outer magneto cover using new gasket and secure with the cap screwsUsing the pattern shown, tighten to ft-lb
2Remove the nut securing the movable drive face; then remove the faceAccount for spacer and flat washerGZ212B