2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 103Get this manual
3Clean the countershaft and trigger splines thoroughly and install the inner snap ring onto the shat; then apply green Loctite #620 to the trigger and countershaft splines and install the triggerSecure with flat washer and outer snap ring GZ255
6Install the shift cam stopper spring onto the shift cam stopper and secure with flat washer and flange nutTighten to ft-lb
4Using new gasket, install the speed sensor housing onto the crankcase and secure with two cap screwsTighten to ft-lb
7Install the shift cam plate onto the shift cam shaft and secure with the cap screwTighten to ft-lb