2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 77Get this manual
6Mark all cable tie locations with an appropriate marker; then remove the ties
8Remove the rear spark plug cap; then from the left side, remove the fuel injector connector (A), manifold absolute pressure (MAP) sensor (B), parking brake warning switch (C), reverse override switch connector (D), and idle speed control (ISC) valve (E)
9Disconnect the front ignition coil and remove the front spark plug; then route the engine harness out of the engine compartment
7Disconnect the negative battery cable; then from the right side, disconnect the engine coolant temperature (ECT) sensor (A), inlet air temperature (IAT) sensor (B), fuel pumpfuel gauge connector (C), rear ignition coil (D), and throttle position sensor (TPS) connector (E)PR596