2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 73Get this manual
9In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 6-7) to 10 ft-lb AT THIS POINT
After completing center crankcase components, proceed to Installing Left-Side Components, to Installing Right-Side Components, and to Installing Top-Side Components
Installing EngineTransmission
NOTE: Arctic Cat recommends that new gaskets and O-rings be installed whenever servicing the vehicle
3Install the flange nuts on the rear engine mount studs; then secure the front engine mounting bracket to the front engine mount studs with two flange nutsTighten the four flange nuts to 45 ft-lb
1Attach suitable lifting chains to the enginetransmission; then using an engine hoist, lower the assembly into the engine compartment
! WARNING
Keep hands and fingers clear when lowering the enginetransmission into placeThe chains could shift causing severe injury