2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 61Get this manual
13Remove the snap ring securing the oil pump driven gear (A); then remove the gear noting the direction of the sides of the gear for installing purposesAccount for pin and washer INSPECTING CENTRIFUGAL CLUTCH SHOE 1Inspect the clutch shoes for uneven wear, chips, cracks, or discolorationIf any shoe is damaged, replace the complete set2Inspect the clutch shoes for wear or damageIf any shoe is worn to the bottom of the groove, replace the complete set
CAUTION
Always replace the clutch shoes as complete set or severe imbalance could occur
ATV1014
INSPECTING CLUTCH HOUSING
14Remove the cap screws securing the oil pump; then remove the pump
1Inspect the clutch housing for burns, grooving, cracks, or uneven wear2If the housing is damaged in any way, the housing must be replacedINSPECTING PRIMARY ONE-WAY DRIVE 1Insert the drive into the clutch housing2Rotate the inner race by hand and verify the inner race rotates only one direction3If the inner race is locked in place or rotates both directions, the drive assembly must be replacedINSPECTING OIL PUMP 1Inspect the pump for damage2It is inadvisable to remove the screw securing the pump halvesIf the oil pump is damaged, it must be replaced