2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 58Get this manual
14Place the water pump into position and secure with two cap screwsTighten securely15Install the crossover tube on the water pump and cylinder head making sure the O-ring is properly positioned16Install the shift arm on the shift arm shaft making sure the scribed marks (from removing) are alignedTighten securely17Place the gasket and outer magneto cover into position on the right-side cover; then tighten four screws to ft-lb
2Remove the nut securing the movable drive face; then remove the faceAccount for flat washer and spacer
Left-Side Components
NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment