2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 53Get this manual
3Using cold chisel, scribe mark showing the relative position of the shift arm to the shift arm shaft to aid in installing; then remove the shift arm
6Remove the two cap screws securing the water pump to the engine; then remove the water pumpNOTE: The water pump is not serviceable componentIf the pump is defective or if the mechanical seal is leaking (coolant dripping from the discharge hole), the water pump must be replaced (see Section 4)
7Remove the cap screws securing the right-side cover to the crankcase noting the location of the different-sized cap screws for installing purposes8Using side case puller, remove the side coverAccount for gasket and two alignment pinsPR429A
4Remove the two cap screws securing the speed sensor housing; then remove the housingAccount for the gasket and two seal washers
NOTE: Inspect the inside of the right-side cover for any shaft washers that may have come off with the coverMake sure they are returned to their respective shafts and that the starter idler gear spacer is on the shaft or in the cover