2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 52Get this manual
26Apply thin coat of Three Bond Sealant to the mating surfaces of the cylinder head and valve cover
32If removed, install the spark plugTighten securely
Right-Side Components
NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
AT THIS POINT
27Place the valve cover into positionNOTE: At this point, the rocker arms and adjuster screws must not have pressure on them
To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-section
NOTE: The enginetransmission does not have to be removed from the frame for this procedure
28Install the four top side cap screws with rubber washers; then install the remaining cap screwsTighten only until snug