2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 48Get this manual
NOTE: The two cylinder-to-crankcase nuts will be tightened in step 10 CC032D
2Place the two alignment pins into positionPlace the cylinder gasket into position; then place piston holder (or suitable substitute) beneath the piston skirt and square the piston in respect to the crankcase
5Install the coolant hose onto the crankcase union and tighten the clampCCylinder Head DValve Cover
NOTE: Steps 1-5 in the preceding sub-section must precede this procedure
6Place the chain guide into the cylinder
CAUTION
Care should be taken that the bottom of the chain guide is secured in the crankcase bossCF083
3Lubricate the inside wall of the cylinder; then using ring compressor, compress the rings and slide the cylinder over the pistonRoute the cam chain up through the cylinder cam chain housing; then remove the piston holder and seat the cylinder firmly on the crankcase