2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 35Get this manual
8Loosen the clamp (A) securing the air intake boot to the throttle body and the clamp (B) securing the air filter housing to the inlet housing boot; then remove the crankcase breather hose from the crankcase PR150A
12Remove the exhaust duct from the V-belt housing; then remove the inlet boot connecting the inlet duct to the V-belt housingPR578A
9Remove two self-tapping screws securing the air filter mounting bracket to the frame; then remove the air filter and mounting bracket as an assembly
10Remove the throttle arm cover from the throttle body; then disconnect and remove the throttle cable and the throttle body
13Remove the muffler; then remove the exhaust pipe14Set the parking brake; then from the underside of the vehicle, mark the flanges of the drive-line couplers for assembling and remove the cap screws (three on the front drive coupler and three on the rear drive coupler) securing the driveshafts to the drive couplersNOTE: Remove the front driveshaft first or the parking brake will not hold the coupler stationary and cap screw removing will be more difficult