2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 33Get this manual
Prowler XTXTX (Table of Contents)
Removing EngineTransmission 3-7 Top-Side Components3-11 Removing Top-Side Components 3-11 Servicing Top-Side Components3-14 Installing Top-Side Components 3-21 Right-Side Components 3-26 Removing Right-Side Components3-26 Installing Right-Side Components3-29 Left-Side Components 3-32 Removing Left-Side Components 3-32 Servicing Left-Side Components 3-35 Installing Left-Side Components 3-36 Center Crankcase Components 3-39 Separating Crankcase Halves3-39 Disassembling Crankcase Half 3-40 Servicing Center Crankcase Components 3-41 Assembling Crankcase Half 3-45 Joining Crankcase Halves3-46 Installing EngineTransmission 3-47
NOTE: Use small funnel between the frame and coolant drain plug to prevent coolant from draining on the frame and splashing
Removing Engine Transmission
Many service procedures can be performed without removing the enginetransmission from the frameClosely observe the note introducing each sub-section for this important information
3Remove the negative cable from the battery; then remove the positive cable4From the right-side, remove the spark plug cap; then disconnect the temperature sensor lead, speed sensor connector, fuel level sensor connector, and reverse override switch connector