2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 25Get this manual
INSTALLING 1Place the V-belt into position on the driven pulley and over the front shaft GZ485A
NOTE: At this point, remove the cap screw from the driven pulley faceGZ085
NOTE: The arrows on the V-belt should point rearward
3Rotate the V-belt and driven pulleyclutch until the V-belt is flush with the top of the driven pulley4Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten the cap screws to ft-lb5Secure the seat-base with the four cap screwsTighten securely6Install the seats and center console making sure the seats lock securely