2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 22Get this manual
3Connect the parking brake cable (see Adjusting in this sub-section)4Adjust the parking brake (see Adjusting in this sub-section)5Connect the lift support to the cargo boxNOTE: Whenever installing new pads, the new pads must be burnished (see Burnishing Brake Pads in this section) PR473A
MEASURINGREPLACING BRAKE PADS (XTZ)
NOTE: The brake pads should be replaced as set
3Remove the two cap screws securing the brake caliper to the rear drive housing and remove the caliper4Remove the anti-rattle springs; then push in on the caliper holder and remove the outer brake padRemove the inner pad
1Disconnect the parking brake cable from the actuator armAccount for flat washer
2Remove the two cap screws and nuts securing the cable support to the brake caliperPR466A
Inspecting and Measuring 1Inspect the pads for gouges, chips, or wear2Inspect the disc for gouges, grooves, cracks, and warpage3Using calipers, measure the thickness of each brake pad4If the thickness of either brake pad is less than 1.0 mm (0.039 in, the brake pads must be replacedNOTE: The brake pads should be replaced as setPR677A