2010 Arctic Cat Prowler XT/XTX/XTZ ATV Service Manual, Page 19Get this manual
ADJUSTING SHIFT CABLE To adjust the shift cable, use the following procedure1Set the parking brake; then remove the seats and center console2Make sure the shift lever is in neutral; then remove the E-clip securing the cable end to the shaft arm Hydraulic Brake System
NOTE: The XTXTX models are equipped with driveline hydraulic and cable-actuated calipers incorporating bleed screw for the hydraulic brake and cable adjuster for parking brake adjustmentThe XTZ models are equipped with hydraulic brakes at all four wheels and cable only actuated driveline parking brake
CHECKINGBLEEDING The hydraulic brake system has been filled and bled at the factoryTo check andor bleed hydraulic brake system, use the following procedure1With the master cylinder in level position, check the fluid level in the reservoirIf the level in the reservoir is not above the MIN, add DOT brake fluid
3Loosen nuts (A) and (B) and adjust the cable housing to align the shift cable end to the shift arm stud (C)